[linux-sparc-users] SSH using IPv6 addressing
Knut Petter Ølberg
kpolberg at kpolberg.net
Thu Feb 2 23:23:31 PST 2017
> On 2 Feb 2017, at 23:51, Paul Drasler <paul.drasler at oracle.com> wrote:
>
> Good day,
>
> Installed my first version of Linux sparc in a LDOM VM, install
> completed successfully. Host platform is a T5.
>
> I have only IPv6 addressing enabled on eth0 but for some reason I am not
> able to ssh into this sparc linux server from other servers using IPv6
> addressing. I am using the command format ssh -6 root at IPv6address
>
> If I enable IPv4 on eth0 then ssh from remote hosts using the IPv4
> addressing works just fine.
>
> I can also ssh into the local linux host using the IPv6 local host
> address, ssh -6 root@::
>
> Is there anything additional that is needed out of the box to get this
> to work?
>
> Linux localhost.localdomain 4.1.12-32.el6uek.sparc64 #1 SMP Thu Dec 17
> 19:27:27 PST 2015 sparc64 sparc64 sparc64 GNU/Linux
>
>
> Any help would be greatly appreciated.
>
> Paul
>
>
> _______________________________________________
> linux-sparc-users mailing list
> linux-sparc-users at oss.oracle.com
> https://oss.oracle.com/mailman/listinfo/linux-sparc-users
https://oss.oracle.com/pipermail/linux-sparc-users/2016-October.txt
# ethtool -K eth0 tx-checksum-ip-generic off
Knut Petter
-------------- next part --------------
An HTML attachment was scrubbed...
URL: http://oss.oracle.com/pipermail/linux-sparc-users/attachments/20170203/aeaa3b44/attachment.html
More information about the linux-sparc-users
mailing list