[Ocfs2-users] initial cluster setup

[Kevin Hulse]

What about /etc/ocfs.conf?

Matthew Boeckman wrote:

> I followed the manuals advice on setting up the initial nodes - and 
> let it create the /etc/cluster/ocfs2/cluster.conf (below) for me. This 
> file is identical on both systems. I restarted o2cb on both systems 
> after this file was in place.
>
> I get conceptually how it all fits together, are you saying that I 
> have a config problem?
>
> cluster.conf:
> node:
>         ip_port = 7777
>         ip_address = 10.1.1.100
>         number = 0
>         name = leto-ii
>         cluster = ocfs2
>
> node:
>         ip_port = 7777
>         ip_address = 10.1.1.33
>         number = 1
>         name = voyager
>         cluster = ocfs2
>
> cluster:
>         node_count = 2
>         name = ocfs2
>
>
> Kevin Hulse wrote:
>
>>
>> Think of the nodes that share ocfs filesystems as
>> a cluster. The configuration and modules for ocfs
>> form a cluster of sorts. The ocfs configuration
>> must be aware of all nodes that attach to the
>> filesystems. Add a node and that shared configuration
>> needs to be changed and updated on all nodes
>> of the "cluster".
>>
>> Didn't you configure any files in /etc for the
>> first node?
>>
>> Matthew Boeckman wrote:
>>
>>> Hello list!
>>>
>>> Just pulled down ocfs2 this morning and installed it on two RHEL 4 
>>> 2.6.9-34 systems. I have followed the manual, but am not seeing some 
>>> things it describes and am not sure what the problem is.
>>>
>>> I guess my first question is - do I need to have a partition 
>>> formatted as ocfs2 on all nodes in the cluster for this to work?
>>>
>>> I have formatted a partition via ocfs2console on node1, and mounted 
>>> it as well. However I cannot figure out how to make that filesystem 
>>> available on node0, where i have not created an ocfs2 partition.
>>>
>>> I've been assuming that formatting as ocfs2 will destroy existing 
>>> data, and don't have a spare partition on node0 yet, I can get one 
>>> if that is required.
>>>
>>> Basically my overall question is how do I mount the filesystem(s) 
>>> from various nodes on each other, or make the whole available to the 
>>> nodes?
>>>
>>> Thanks in advance!
>>>
>>> _______________________________________________
>>> Ocfs2-users mailing list
>>> Ocfs2-users at oss.oracle.com
>>> http://oss.oracle.com/mailman/listinfo/ocfs2-users
>>>
>>>
>>>  
>>>
>>
>>
>>
>
>