[Fwd: Re: [Ocfs-users] Ocfs and EMC Powerpath]

[Bruce Holzrichter]

That should say below, we are using Powerpath on the CX300's AND the
CX600's...

-----------------------------------------------------------------------

We are using Powerpath with CX300's and Emulex HBA's, also with OCFS on
Red Hat 2.1 AS.

Kernel upgrades are the biggest issue that we have, as some of the
drivers are dependent on modules built for specific kernels, and if your
not careful you can have boot issues with them.

I would suggest at least kernel e59 and OCFS v1.0.14.

Powerpath may only be supported to v3.7 on that 2.1 platfrom, but I
would doublecheck that with EMC support matrix.

We had issues with iostat statistics as well, but they seem to be better
with the latest systat packages, so make sure you update that as well.

Other than that, they seem to work fine.

Hope that helps.

Bruce Holzrichter

On Thu, 2005-08-04 at 09:12 -0700, Kendall, Kim wrote:
> A couple years ago, we moved to Oracle RAC on Linux using ocfs that is
> SAN attached to an EMC CLARiiON. At the time, there was a reason that we
> did NOT use EMC's Powerpath (I just can't recall what that reason was).
> 
> What I'd like to know is if there are any issues with introducing
> Powerpath now. 
> 
>  * RHEL 2.1 AS
>  * 2.4.9-e.38enterprise
>  * ocfs-2.4.9-e-enterprise-1.0.13-1
>  * EMC CLARiiON CX600
> 
> Thx!
> ----
> Kim Kendall       Sr Unix Administrator
> Inter-Tel, Inc.   http://www.inter-tel.com/
> Tempe, Arizona    480-449-8900  x18078
> 
> _______________________________________________
> Ocfs-users mailing list
> Ocfs-users at oss.oracle.com
> http://oss.oracle.com/mailman/listinfo/ocfs-users